Blackened Base Plate - 132
Base flange, usually used for uprights on level sites. Fixing holes suit a wide range of common mechanical and chemical masonry anchors, which we should be pleased to quote for on request.
Warning: To achieve optimum load characteristics, this fitting should be fitted so that the fixing holes are in line with the applied load.
Please note that these products are for indoor use only and are NOT suitable for use outside. These products have been treated to give the aged effect and have not been powder coated.
All our clamps are supplied complete with grub screws. Additional replacement screws can also be purchased click here
Please note that the tube we stock goes into the fittings by approximately 25mm to 30mm. This figure is for guidance only.
Important: This product contains fixing holes. We do not recommend pre-drilling prior to receiving the product as there can be irregularities in casting that can produce small variations in the size of the holes. Any measurements shown should be regarded as a guideline only.
Through bolt, thunder bolt and 12mm SDS drill bit shown below are NOT suitable for use with 26.9mm tube clamps.