We use cookies to provide core website functionality, to analyse our traffic and to personalise content and ads. We also share information about your use of our site with our social media, advertising and analytics partners who may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services.
Base flange for sloping sites, adjustable from 11° to 29°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required,type 132 is normally used, with the upright tube bent to the required angle.
The tubes are shown in red for marketing purposes only, to show the detail on the clamps.
All our clamps are supplied complete with grub screws. Additional replacement screws can also be purchased click here
Please note the through bolt, thunder bolt and 12mm SDS drill bit are NOT suitable for use with 26.9mm tube clamps.
Important: This product contains fixing holes. We do not recommend pre-drilling prior to receiving the product as there can be irregularities in casting that can produce small variations in the size of the holes. Any measurements shown should be regarded as a guideline only.
If you’re not sure what you need,
then we’re just a call away
